Hach sc200 pH/ORP/DO Module Manuel D'utilisation page 6

Table 3 pH and ORP sensor wiring – sensors with fixed cables (continued)
Terminal
2-pin (J4) 1
2
Sensor shield wires – Connect all sensor
ground/shield wires to the controller enclosure
grounding screws.
Table 4 pH and ORP sensor wiring – sensors with removable cables
Terminal
8-pin (J5) 1
2
3
4
5
6
7
8
2-pin (J4) 1
2
Sensor shield wires—Connect all sensor ground/shield
wires to the controller enclosure grounding screws.
Notes:
1
If an electrode with a ground solution is used, connect the wire to pin 2 on J5 and do not make
a jumper. For the VP-Plug, use the blue wire.
6 English
Description
Differential
Active
—
Clear with a black
Description
Top68 (with temp)
Reference Black shield
Ground solution Jumper 1–2 on J5
–V supply
—
—
Temp
Temp/–Circuit low
—
Active Black signal
—
Sensor with an attached cable
8350
sensor
Red Transparent (coax
core)
—
band
Cable type (connector)
SMEK
Black
Jumper 1–2 on J5
— —
— —
— —
(Red) Green
(White) White
— —
Transparent
— —
—
Green/yellow
—
The yellow and
brown wire are not
used.
8350.3/4/5
Transparent (coax
core)
— —
— Blue
VP-Plug
Red
Jumper 1–2 on J5
—
—
—
Green
White
—
Black/transparent
—
(Green/yellow)
The gray wire is not used.
1