LGB 21151 Instructions De Service page 8

"round" lighting connectors, use
the Light Socket Adapter (68334).
Smoke Generator
This model has a smoke genera-
tor in the smokestack. There is a
small silver switch on the bottom
of the loco, directly under the
smoke stack (Fig. 1). To turn the
smoke generator on, turn the
switch until it touches the brass
contact.
A small supply of LGB Smoke
and Cleaning Fluid is also inclu-
ded with this model. For best ope-
ration, fill the generator halfway
with fluid. If the generator is over-
filled, it will not convert the fluid
into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010) in the
smoke generator. Other fluids
may damage your locomotive.
Attention! Never touch the hea-
ting element in the center of the
smoke generator. It is fragile.
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies may void your warranty.
For this model, we recommend an
LGB power supply with a power
output of 1 amp or more. For more
information on LGB power sup-
plies for indoor, outdoor and multi-
train operation, see the LGB cata-
log.
Attention! After extended opera-
tion, this model may leave a small
amount of carbon dust around the
track. This dust can stain carpet
and other materials. The user
assumes full responsibility for any
damage.
MAINTENANCE
Attention! Improper service may
void your warranty. For factory
authorized service, contact an
authorized retailer or send this
product to an LGB service station
(see Factory Service).
Lubrication
The axle bearings and drive rod
ends should be lubricated occa-
sionally with a small amount of
LGB Maintenance Oil (50019).
8
Cleaning
This model can be cleaned using
a mild detergent and gentle stre-
am of water. Do not immerse this
model. If this model is equipped
with sound electronics, do not
expose the speaker directly to
water.
Replacing the light bulbs
Front lanterns: Carefully pry the
lens away from the lantern. Using
tweezers, remove and replace the
bulb. Reassemble.
Rear lantern: Pull the lantern
housing away from the model.
Pull the socket out of the housing.
Replace the bulb. Reassemble.
Replacing the smoke generator
The smoke generator is an inte-
gral part of the smoke stack. To
replace the stack:
- While holding on to the large sil-
ver nut on the bottom of the loco,
turn the old smoke stack out of
the nut.
- Slide the old smoke stack out of
the loco.
- Slide the new smoke stack into
the loco
- Turn the new smoke stack into
the nut.
Replacing the traction tire
- Use a small, straight-blade
screwdriver to gently pry the old
traction tire out of the wheel
groove.
- Gently warm the new traction
tire in a dish of warm water.
- Use a small, straight-blade
screwdriver to gently pry the
new traction tire into the wheel
groove.
- Make sure that the traction tire is
completely in the wheel groove.
Replacing the loco motor
We strongly recommend factory
replacement of this motor. For
factory authorized service, con-
tact an authorized retailer or send
this product to an LGB service
station (see Factory Service).
Replacing the loco brushes,
pick-up shoes and wheelsets
Remove the the four screws on
the bottom gearbox plate, and
remove the plate. Replace the
necessary parts. Reassemble.
Attention! If the wheelsets are
replaced, generously lubricate