Installation Of Type 6013; Start-Up; Safety Instructions - Burkert 6013 Manuel D'utilisation

Masquer les pouces Voir aussi pour 6013:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.2.

Installation of Type 6013

Any installation position.
Preferably with magnet system face up.
1.
Clean pipelines.
2.
Any installation position
Preferential direction with actuator face up.
3.
Connect dirt trap upstream
Observe direction of flow!
4.
Seal
PTFE.
5.
Screw in pipelines
Observe direction of flow!
6.
Install / remove.
NOTE!
Information for devices with connecting cable:
Connecting cable and coil are encapsulated. They must not be
removed!
Always connect protective conductor!
7.
Connect to power supply.
14
english
PTB 00 ATEX 2129 X

Start-up

8.
START-UP
8.1.

Safety instructions

WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
• Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/
the device.
8.2.
Start-up
Before starting up the device, ensure that:
• the device has been installed correctly,
• the connection has been made properly,
• the device is not damaged,
• all screws have been tightened.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

0742

Table des Matières