Troubleshooting - Amprobe TMA40 Mode D'emploi

2. Select TMA40 and click on "next"
3. Click on "next" and then "next" to download information from the device
4. Click "next", then "yes", and then "finish" to complete the downloading
5. Click on "Visualizations" to select measurement table
6. Select the parameters you want to visualize and click oK (See fig.6)
NB. Refer to help menu for more details on how to use the download Suite.

TROUBLESHOOTING

Power on but no display
• Make sure the time of pressing "on/off" key is more than 0.2 seconds.
• Check the batteries are in place and make sure they are at good contact and correct polarity.
• Replace the batteries and try again .
Display disappear
• Check whether the low battery indicator is displayed on or before display disappears. if yes,
replace the batteries .
Error code:
• e2. problem : Meter value is underflow .
• e3. problem : Meter value is overflow.
• e4. problem: Calculated source value occurs error.
9