Fitting Your Cat Fl Ap - Petsafe Staywell 900 Série Guide D'installation

b) In Glass
Glass windows & doors, single and double glazed*
* It is not possible to cut holes in toughened glass or double glazed units
except at the time of manufacture. Please consult a glazier.
The cat fl ap requires a circular cut-out with a diameter of 210 mm (Fig. 4).
FIG.4
210mm
Not to scale - for best results you should
refer your glazier to the enclosed
cutting template.
c) In Walls
Fits brick walls
Follow the instructions for "Wood and PVC/uPVC/Metal", by using the
enclosed cutting template. Please note that additional tools, materials and
competent DIY skills may be required.
Fitting your cat fl ap
Your PetSafe
on the inside of your house.
Temporarily place the cat fl ap in the hole and position the outside cover
on the outside of the house. From the outside mark screw holes on the
door through the holes in the outside cover (Fig. 5).
Remove the cat fl ap and drill the holes with a 5 mm (
FIG.5
Replace the cat fl ap in the hole and from the outside screw into place (Fig. 7).
If the screws are too long they may need to be cut down to match the
depth of your door. Using over long screws may damage the cat fl ap.
The screws should be removed from the cat fl ap before cutting. File down
to ensure there are no sharp edges.
Finally, cover the screw holes with the blanking plugs on the outside
frame to ensure a neat fi nish (Fig. 7).
Replacement fl aps available online
cat fl ap is fi tted with the red 4-way lock
®
3
FIG.6
/ ") drill bit (Fig. 6).
16
5