Headboard Brackets (Not Included) - TEMPUR-PEDIC UP 2.0 Manuel Du Propriétaire

headboard bracket installation guide (optional)
Headboard Brackets are an optional accessory and are not included.
A 9/16" (14mm) socket wrench and 1/2" (13mm) crescent wrench are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which
the leg threads. Hold the bracket in place and screw the leg
into the base until it is snug. DO NOT OVERTIGHTEN. Too
much force may cause the leg to spin freely.
b.) Align the tab with the hole in the frame (located towards
the foot of the base) and use a short bolt and nut to secure
the bracket. Make sure the bolt is tight.
STEP 2
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b.) To install the plastic spacer and attachment plate, you
will need (2) long bolts and (2) nuts. Place the spacer
and attachment plate in the desired location and slip the
bolts through the holes with the head of the bolt facing
outward. Position the bolts diagonally on the spacer.
Use the 9/16" (14mm) socket wrench and 1/2" (13mm)
crescent wrench to tighten the bolts.
STEP 3
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets. The heads of the bolts will face outward. Use the 9/16"
(14mm) socket wrench and 1/2" (13mm) crescent wrench to
tighten the bolts.
11