Headboard Brackets (Not Included) - TEMPUR-PEDIC ERGO Manuel Du Propriétaire

headboard bracket installation guide (optional)
STEP 1
a.) Align the hole in the bracket to the brass sleeve into
which the leg threads. Hold the bracket in place and
screw the leg into the base until it is snug. DO NOT
OVERTIGHTEN. Too much force may cause the leg to
spin freely.
b.) Align the tab with the hole in the frame (located towards
the foot of the base) and use a short bolt and nut to
secure the bracket. Make sure the bolt is tight.
STEP 2
Attach the T-Bracket.
a.) Measure the distance between the mounting holes
on the headboard and install the T-Bracket to
accommodate the headboard.
16
Headboard Brackets are an optional accessory and are not included.
b.) To install the T-Bracket, slide the T-Bracket through the
end of the headboard bracket. Align the flat side of the
T-Bracket plate to the mounting holes on the headboard.
c.) Secure T-Bracket in place by inserting two short screws
through top of bracket. Use hex key to tighten screws.
STEP 3
Connect your headboard to the attachment plate using the
remaining long screws or hardware that came with your
headboard. The heads of the bolts will face outward. Use
hex key to tighten bolts.