EUROM Mon Soleil DSP Wifi Manuel D'utilisation page 65

 If you would like to delete a specific setting, press and hold WEEK and then
search for the timer setting that you need. Go past 01- ][ and on/off first by
pressing SET briefly. When the number of the timer setting that you wish to
change appears, press SET for a little longer. You will hear a short beep and the
selected setting has been deleted.
 If you wish to delete all timer settings, press the WEEK button and hold. Press
and hold the MOD and SET buttons at the same time, until you hear a beep. The
screen will show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the
operating panel, not with the remote control!
 If you wish to retain the timer details but do not want to use the timer for a
while, push and hold the WEEK button and then push and hold the MOD until
TIME disappears from the screen to indicate that the data will be retained but
will not be active. By pressing MOD again until TIME appears, you will reactivate
the timer.
Screen protection: If the settings on a working heater are not adjusted for 2
minutes, the LED display will go out but ON will stay on. It will light up again when
you press a button. If the heather is switched off using the ON/OFF button, the OFF
screen will stay on.
Using with the remote control
The remote control (4) has the same 6 buttons as the operating
panel (MOD = MODE) and works in roughly the same way, but:
 You cannot use the remote control (under M-mode) to set the
capacity with the + or - buttons. Use the bar button
for this purpose.
 The remote control has an ECO button for an energy efficient
mode; the heater maintains the room at 16°C. The screen
shows EC. Deactivate by pressing ECO again. Nothing
else can be set under this setting. If the heater is
working on ECO setting and a timer setting becomes
active, the heater will start to work according to the
timer setting. When the heat goes off, the heater will not
return to the ECO setting, but go off.
 The remote control also has an open-window detection; when
you choose this function, the heater will turn itself off
when the temperature in the room drops by 8 or more
degrees in 15 minutes. Turn the heater on again with
the on/off button. Press the symbol again to cancel
the open-window detection. The heater will begin to work in the pre-set
function. When the heater operates according to a set week programme and you
turn on the open-window detection, the heater will only work during the set
operating times of the week programme.
65