EUROM Mon Soleil DSP Wifi Manuel D'utilisation page 63

Using for the first time and operation
 Check to make sure the main switch is set to O (off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The display will show: OFF
External temperature sensor (5)
Because the temperature sensor is located on the heater,
it does not measure the external temperature very
accurately. If you want accurate measuring, connect the
separate thermostat (included in the delivery) by inserting
the small plug into the control panel and placing the
sensor approx. 2 metres away from the heater (see
illustration). For this purpose, you should remove the
heater from the wall and subsequently, place it back.
When you have connected the separate thermostat, it
automatically takes over the thermostat operation.
Using the operating panel
The operating panel (2) has 6 buttons:
MOD / SET / WEEK / + / - / ON-OFF
 Press the ON/OFF button in order to switch the heater on. The display lights up
and the heater can be operated.
 Now, set the day and time. Press and hold SET until SET appears on the screen.
The numbers of the weekdays (line 4) will blink. Use the + and – buttons to find
the right day (1 – Monday, 2 = Tuesday, etc.) and confirm with SET. The hour
will now blink. Use the + and – buttons to set the right hour and confirm with
SET. The minutes will now blink. Use the + and – buttons to set the right
minutes and confirm with SET. The day and time are now set.
Please Note:
The day and time settings will be lost if the heater is switched off using the
o
main switch or plug; these will be retained if the ON/OFF button is used.
If you do not set a time and day, the heater will assume that it is day 1 and
o
00.00.
The screen goes off automatically after 2 minutes and can be turned on again
o
with any button.
 Press MOD to set whether you wish to work with the M or P function.
 You can now turn On (1 sun) or turn Off (no sun) the heater using the + and –
buttons under M-function (remote control: the button with the bars). The
thermostat cannot be adjusted.
 Under the P-function, you can use the + and – buttons to set the desired
temperature for the heater, which it will then try to maintain. Once the desired
63