Eliminating Minor Faults Yourself - Bosch GSV Série Mode D'emploi

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Warning signal sounds.
Temperature display flashes.
Fig. "/2
Appliance is not cooling,
temperature display and light
are lit.
36
Possible cause
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Fault - the freezer
compartment is too warm!
Frozen food is at risk.
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed in
the freezer at once.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether the power
is on, check the fuses.
To switch off the warning signal, press the
temperature setting button, Fig. "/4.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been rectified, the
temperature display stops flashing.
Hold down temperature selection button
fig. "/4 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.