After Use Storage - Bosch AQUATAK 150 PRO Instructions D'emploi

F016 L70 375 - GB Seite 5 Montag, 14. November 2005 1:15 13
Maintenance
Stop, remove plug from the power sup-
ply and disconnect from water supply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the pressure washer should happen to fail despite
the care taken in manufacture and testing, repair
should be carried out by an authorised service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (TYP) from
the nameplate of the machine!
Cleaning/inspecting the strainer
S Expose the strainer 18 in the machine water inlet
connection by removing the inlet connector 16.
The strainer 18 can be easily removed with long
nose pliers. Rinse and replace. If damaged replace.
Never use the pressure washer without the strainer
or a damaged strainer.
17 • F016 L70 375 • TMS • 21.10.05
Transport
To move the machine use the top handle and roll the
machine on the wheels.
To transport the unit up or down steps or over obsta-
cles, it must be lifted by the top handle.
If the unit is to be stored or transported horizontally
the detergent tank should be drained first.

After use storage

Clean the exterior of the machine thoroughly using a
soft brush or cloth. Do not use water, solvents or pol-
ishes. Remove all debris, especially from the venti-
lation slots.
Frost will damage a pressure washer that has not
been completely emptied of water. The machine
should be stored in a frost free room.
Do not place other objects on top of the machine.
Ensure cables are not trapped when storing. Do not
kink high pressure hose.
English - 5