Burg Wächter secuENTRY ENTRY Pincode Guide De Montage page 48

You can then decide whether you want to glue the wall holder directly on
the wall or whether you prefer having it screwed on. The slotted holes in the
wall holder provide for an exact alignment.
If you decide for gluing the wall holder, please be sure to provide for clean
surfaces free from fat, oil and silicon films and any other impurities. Remove
completely the protective film from the included adhesive pads, attach
all the pads on the wall holder and then press it firmly to the required
position. When mounting in colder temperatures, please remember that
the full adhesive force cannot be achieved before 72 hours in 20°C, with
warmth accelerating the process (e. g. in 65°C, the full adhesive force will be
achieved in one hour).
When attaching the holder plate on the coloured sight protection film, the
above described conditions relating to cleanliness of surfaces and firmness of
the adhesive pad should be observed.
To provide for a bubble-free application of the colour sight protection film,
please proceed as follows:
• Pour some water with a couple of drops of dishwashing detergent into a
glass, stir it cautiously free of foam, and then use it to moisture gently the
surface, on which the film is to be applied.
• Start pulling off the white protective sheet from 1 cm of film and straighten
it out. To change the position, lift this surface carefully and attach it again
as required.
• Then swipe the adhesive film, e. g. with a plastic spatula, out from the
contact surface in the direction of protective sheet still attached.
Attention! Do not use more liquid than absolutely necessary.
• Slide the keypad in from above until the locking
peg of the mounting plate engages into the
keypad housing. In this way, the keypad is
protected against undesired removal.
• Perform a function test of the unit with the
door open. For this purpose, enter repeatedly
a valid opening code (e. g. PIN code,
fingerprint, ...).
50 | English secuENTRY