Burg Wächter secuENTRY ENTRY Pincode Guide De Montage page 47

14 Connect the cable with the plate using the plug and stow the remaining
cable in the side pocket intended for this purpose.
15 Inset the battery with the correct polarity and snap on the sleeve.
Please remember: The fixing is possible in just one position!
16 Put the inner knob on the cylinder or on the appropriate adapter and
fasten it with the corresponding screw. Table 1 provides the required
dimensions.
17 Place the sleeve and snap it in.
Installation instructions for secuENTRY keypad
The keypad is only included in ENTRY Pincode and ENTRY Fingerprint sets.
Attention! Please remember that the keypad should not be attached
to the door itself, otherwise it would transmit shocks when the
door is being shut. The membrane affixed to the keypad rear side
should not be sealed with glue and / or any other substance under
any circumstances! Exchange of air must also be possible after the
installation!
• Determine the installation place for the keypad. For that purpose, enter the
opening code (e. g. PIN code, fingerprint, ...) at the desired mounting place
and check whether the lock opens.
• Place the keypad correspondingly.
secuENTRY English | 49