Setting The Time - Burg Wächter secuENTRY ENTRY Pincode Guide De Montage

Delete submenu
• Switch on the keypad using the key
• Then press FUNC – "Menu/Code Change" appears
• Scroll using the 2 key until the Administrator menu appears
• Confirm your selection using
• Scroll with the 2 key until "Delete Admin. setting" appears
• Confirm your selection using
• Enter the administrator code in order to acquire the authorisation for
programming
• Scroll to the identification medium that you want to delete and
confirm 2x using
• I"Data deleted" appears in the display
Time Functions submenu (Premium only)
This is intended for setting the time and date

Setting the time:

Not available as a standard function.
Setting the date:
Not available as a standard function.
Setup submenu
General system settings
Register
After a replacement of the cylinder or the keypad, the two units have to be
newly aligned, so that they can resume communication. Attention! Before
registering a keypad, the ENTRY cylinder must be awakened. This is
done by opening the lock once with a transponder. Then you have
1min time for the login process.
Registration of a keypad
• Activate the keypad using the
• Then press FUNC, ‚Menu / Code Change' is displayed
• Scroll using the 1 or 2 key till reaching the ‚Administrator menu'
• Confirm with
• Scroll using the 1 or 2 key until reaching the "Setup" menu item
• Confirm with
• Enter the admin code of the unit to be registered
• "Data has been saved" is displayed after a successful registration
Attention! Make sure that no other powered secuENTRY unit is
placed within a direct reach of the device when registering a new
keypad or a new cylinder, as such unit could be mistakenly addressed
instead of the intended one. When in doubt, disconnect such units
from power before the registration (remove batteries).
secuENTRY
key
English | 41