Safety; Installation; Use; General Safety Standards - Bartscher JET 110.425 Mode D'emploi

CUTLERY DRYER Models JET - MIG

SAFETY

Installation

• Check that the machine has not been
damaged during transport. If the machine is
damaged contact the supplier.
• Installation of the machine and connection
to the electrical power supply must only be
performed by qualified personnel. Before
performing any work,
machine is disconnected from the electrical
power supply.
• For reasons of safely, do not modify or alter
the machine in any way.
• Make sure the machine does not rest on the
power cord.
The manufacturer shall not be held liable for
personal injury or property damage which may
be due to:
• Modification or actions that are not explicitly
authorized.
• Incorrect installation or installation performed
by unqualified personnel.

Use

• The machine was designed to dry and polish
cutlery made of stainless steel, chromed steel
or silver, using corncob. Do not use it for drying
or polishing other materials.
• For drying and polishing, insert in the machine
only corncob.
• The machine may only be used by persons
who have been suitably trained to operate
and monitor it.
• The machine may be used only in closed
locations with adequate health and hygiene
conditions and sufficient lighting (300-400 lux).
The manufacturer shall not be held liable for
personal injury or property damage which may
be due to:
• Use of the machine which is improper,
incorrect or not in compliance with the
instructions.
• Methods of use that do not comply with
current laws and standards.
• Use of the machine by untrained personnel.
CDJET-MIG-T-00-07 Use and maintenance manual
check that the

General safety standards

• Repairs
to the machine
performed by specialized personnel. If there
are problems with the machine, do not
attempt to repair
performed by unskilled persons may lead to
damage and accidents.
• In the event of malfunctions, refer to this
manual. Contact your dealer if you are not
able to find the necessary information.
• When replacing components of the machine,
insist on original spare parts.
• Periodically perform required cleaning and
maintenance, as specified in this manual;
• In the event of prolonged disuse, empty the
corncob from the machine and unplug it from
the electrical power supply. Never unplug by
pulling on the cord. Unplug by grasping the
plug.
The manufacturer shall not be held liable for
personal injury or property damage which may
be due to:
• Failure to perform required maintenance, or
doing so carelessly.
• Incorrectly performed maintenance.
• Maintenance not performed by specialized
personnel, when required by this manual or by
current standards.
Page 3 of 20
must only be
it by yourself. Work
CE