Installation; Positioning The Machine; Description Of The Machine; Important - Bartscher JET 110.425 Mode D'emploi

CUTLERY DRYER Models JET - MIG

INSTALLATION

Data on electrical connections is included on
the ratings plate located on the back of the
machine.
Before inserting the plug in the socket, make
sure that:
1. The mains voltage specified on the ratings
plate corresponds to the mains voltage at
the place of installation.
2. The counter, the fuses, the power supply line
and the socket are sized to support the
maximum required current.
The machine is supplied with a 4-metre power
cord with a SCHUKO model plug. Make sure that
the power socket in the place of installation of
the machine and the plug are compatible
without using reductions, multiple sockets and
various adaptors.
ATTENTION!:
accessible even after the appliance
has been installed.
If you need to replace the power cord,
contact qualified personnel.
ATTENTION!: The machine must be
connected to a socket protected by a
circuit breaker and an effective earth
system. The manufacturer shall not be
held liable if these instructions are not
followed.

Positioning the machine

Before positioning the machine, remove all
packing materials.
For correct positioning, consider the dimensions
of the machine as shown in the technical data
at the end of this manual.
To keep the machine from overheating, leave a
free space around it of at least 10 cm.
If the machine is equipped with wheels, once
you have positioned it, you will need to lock it in
place using the brakes on the front wheels. If it is
equipped with support feet, you will need to
level it by adjusting the feet.
CDJET-MIG-T-00-07 Use and maintenance manual
The plug must remain
ATTENTION!: Make sure the power cord
does not interfere with work and that
workers will not trip over it.
ATTENTION!: Before you plug in the
machine, turn the main switch to
position 0.

DESCRIPTION OF THE MACHINE

This CUTLERY DRYER is an automatic machine
that has been designed and created for the
drying of cutlery made of stainless steel,
chromed steel, or silver.
IMPORTANT!: To dry cutlery made with
other types of materials, it is advisable
to run tests first to evaluate the quality
of the results.
The machine is intended for use in the kitchens
and dishwashing areas of hotels, restaurants,
pizzerias and other dining facilities.
The entire structure is made of stainless steel,
which allows easy cleaning and disinfecting.
The entire machine is composed of a stainless
steel spiral tunnel that contains the corncob, an
adhesive heating element and a motor-vibrator.
Page 4 of 20
CE