What To Do If - Bartscher JET 110.425 Mode D'emploi

CUTLERY DRYER Models JET - MIG

WHAT TO DO IF...

The instructions shown below may help you solve some of the problems which may arise with the
CUTLERY DRYER
ATTENTION!: Before doing any work inside of the machine, disconnect the power supply by
turning the main switch to 0. Also pull the plug from the socket.
Problem
JET and
The machine will not JET and
turn on
JET and
The machine will not
start
The machine is on but
JET and
the heating element
does not heat up
During use, the circuit JET and
breaker trips
JET and
At the end of the
JET and
cycle, the cutlery is still
damp
JET and
JET and
JET and
JET and
JET and
JET and
The cutlery does not
come out
JET and
JET and
JET and
JET and
JET and
CDJET-MIG-T-00-07 Use and maintenance manual
Model Possible cause
The switch for protection of the power
MIG supply line is open
The plug of the machine is not inserted
MIG correctly
The protection fuse is burned out
MIG
JET The lid is not positioned correctly
The heating element, cable or thermostat
MIG are damaged
There is dispersion to earth of the
MIG electrical circuit
The cutlery was not properly drained prior
MIG to insertion
Heating element malfunction
MIG
The corncob has not reached optimal
MIG drying temperature
Too much cutlery is inserted
MIG
The cutlery is jammed inside the tunnel
MIG
There may not be enough corncob in the
MIG machine.
The corncob may be damp
MIG
Malfunction of the motor-vibrator
MIG
The motor of the motor-vibrator has
MIG burned out
The cutlery is jammed inside the tunnel
MIG
The fan does not function
MIG
There is too much corncob in the
MIG machine
The corncob may be damp
MIG
Page 11 of 20
Remedy
Close the switch
Check that the plug is inserted correctly
Replace the fuse
Position the lid correctly
Contact the dealer's service centre
Unplug the unit and contact the dealer's
service centre
Put the cutlery through another drying
cycle
Contact the dealer's service centre
Wait longer before inserting the cutlery
Reduce the amount of cutlery inserted.
Remove the lid of the machine, raise the
handle of the tunnel after removing the
three black fastening knobs and remove
the jammed cutlery
Extract the corncob, weigh it and return the
correct amount to the machine.
Replace the corncob or leave the machine
running until the corncob is regenerated.
Contact the dealer's service centre
Contact the dealer's service centre
Remove the lid of the machine, raise the
handle of the tunnel after removing the
three black fastening knobs and remove
the jammed cutlery
Contact the dealer's service centre
Extract the corncob, weigh it and return the
correct amount to the machine.
Replace the corncob or leave the machine
running until the corncob is regenerated.
CE