Cutlery Drying - Bartscher JET 110.425 Mode D'emploi

CUTLERY DRYER Models JET - MIG
Cutlery
exit
opening
Figure 1 – CUTLERY DRYER
model JET

Cutlery drying

Cutlery, with the maximum dimensions shown in
Figure 3, is inserted in the entry opening located
on the top of the machine. From there, it
reaches the bottom of the spiral tunnel. In the
tunnel, there is the corncob, which is heated by
an adhesive heating element applied to the
outside of the bottom of the tunnel, allowing it
to reach the required
approximately 80°C needed to disinfect the
cutlery. The motor-vibrator, located in the
centre of the spiral, allows the cutlery to
proceed along the tunnel until the exit opening,
located on the front of the machine. The
relative movement between the cutlery and
corncob allows the corncob to absorb the
humidity from the cutlery and to polish it.
Near the exit hole, in addition to a perforated
track that allows the corncob to return to
circulation. There is
generates and air barrier capable of keeping
the cob in the machine.
CDJET-MIG-T-00-07 Use and maintenance manual
Cutlery
entrance
opening
Figure 2 – CUTLERY DRYER
model MIG
temperature
an electric fan that
50 MAX
Figure 3 – Maximum dimensions of cutlery
of
Page 5 of 20
30 MAX
CE