Starting Up; Battery Charging; Operation - Kärcher OC 3 Mode D'emploi

*Conical jet nozzle for gentle cleaning
8
*Universal brush
9
Flat jet nozzle
10
Water reservoir
11
Water reservoir cover
12
Carrying handle for the water reservoir
13
Storage compartment for small parts
14
Valve opener
15
Fine filter
16
Type plate
17
*Suction hose
18
*Suction hose connection
19
*Water filter
20
*Cap
21
*Accessories box
22
*Viscous cloth
23
*Fur cleaning brush
24
*Microfibre cloth
25
* optional
Blink codes

Starting up

1. Place the device on a flat and level surface.

Battery charging

1. Charge the battery.
Illustration B
Note
The charge indicator flashes during the charging proce-
dure. This lights up continuously when the battery is ful-
ly charged. For information on the charging time, see
Chapter Technical data.
Water supply
ATTENTION
Contamination in the water
Damage to the pump and accessories
Fill the reservoir with clear water only.
Ensure that only clear water is sucked in.
Battery is being charged.
The battery is fully
charged.
Low battery voltage warn-
ing (approx. 2 minutes op-
erating time remaining).
The battery is discharged.
The device switches itself
off and cannot be switched
back on.
The motor circuit breaker
has tripped (see Chapter
Troubleshooting guide).
Water supply from integrated water reservoir
ATTENTION
Improper water supply
Damage to the device
Do not fill the water reservoir with any detergents, pes-
ticides or other additives.
Do not immerse the device in water.
Remove the water reservoir for filling.
1. Pivot the carrying handle of the device to the side.
Illustration C
2. Pull the water reservoir vertically upwards.
Illustration D
3. Open the water reservoir lid and fill the water reser-
voir.
Illustration E
4. Fit the water reservoir on the device.
Illustration F
Note
Take care to ensure that the low-pressure hose lies
in the recess and is not crushed.
Sucking water from open containers
1. Pull the water reservoir vertically upwards.
2. Remove the valve opener using the suction hose
connection or a suitable pair of pliers.
Illustration G
3. Plug the suction hose connection onto the fine filter.
Illustration H
4. Remove the fine filter using the suction hose con-
nection or a suitable pair of pliers.
Illustration I
5. Remove the fine filter from the suction hose connection.
6. Fit the suction hose connection into the device and
fasten in place by turning it 90°.
Illustration J
7. Hang the suction hose with the integrated filter into
the water source (e.g. rainwater drum).
ATTENTION
Loss of valve opener and fine filter
Device cannot be operated
Store the valve opener and fine filter in the storage com-
partment provided.
Fit the valve opener and fine filter before using the de-
vice with the water reservoir. Ensure that the pin of the
valve opener points upwards.

Operation

ATTENTION
Pump running dry
Damage to the device
If pressure does not build up in the device after 2 min-
utes then switch the device off and proceed according
to the instructions in chapter Troubleshooting guide.
1. Press the power switch.
Illustration K
2. Press the lever of the trigger gun.
Approx. 2 minutes before the operating time ends (see
Chapter Technical data), the charge level indicator will
start to flash.