Festo DSBC-40-30-PPVA-N3 Notice D'utilisation page 15

Pneumatic linear cylinder
Use the same medium composition
S
throughout the service life of the product.
Example:
selected: non−lubricated compressed air
continue to use: non−lubricated com
pressed air.
Slowly pressurize the complete system.
S
This will prevent uncontrolled movements
from occurring.
4 Installation
Mechanical installation
Check whether the type designation of the cylinder to be fitted is the same as
S
that of the desired cylinder.
Handle the cylinder with care so that the
S
cylinder barrel and the piston rod are not
damaged.
This would reduce operational reliability
and the service life.
Place the cylinder on the support so that
S
the adjusting screws for the end position
cushioning are always accessible.
Make sure that:
S
external guides, if used, are fitted
parallel,
they are not distorted and
the maximum permitted loadings as
per catalogue are not exceeded.
Observe the maximum tightening torques specified in the catalogue for
S
screws, locking nuts or accessories.
Festo 0506a English
Fig. 3
Fig. 4
Fig. 5
Fig. 6
15