Time Control - Mennekes AMTRON Xtra Manuel D'utilisation

5.1.2 "Time control"

Operating mode "Time control"
Start of charg- Without RFID card:
ing process „ Automatically after connection to the vehicle
With RFID card:
„ Authentication with valid RFID card
„ Manually via the MENNEKES Charge APP by selecting a valid RFID card.
Controlling the By using the internal timer:
charging pro- „ Adjusting the charging current depending on the active period (main / off-peak tariffs)
cess
Via the MENNEKES Charge APP:
„ Terminating the charging process.
By using the multifunction button:
„ Terminating the charging process.
The stop function with the multifunction button must be enabled during the setting-up process.
With RFID card:
„ Terminating the charging process with the same card used for starting the charging process.
Setting up the f Make settings in the MENNEKES Charge APP
operating mode
Changing the By using the MENNEKES Charge APP during a charging process:
operating mode „ Change to operating mode "APP control".
The change of operating mode will apply to the on-going charging process. The following charging
process is performed in the mode selected in "Configure Wallbox".
Via the MENNEKES Charge APP in "Configure Wallbox":
„ Changing to all operating modes configured during the setting-up process.
The change of operating mode will apply for the on-going and subsequent charging processes.
Behaviour after The behaviour after a power failure is configured during setting-up process.
a power failure „ The charging process is aborted (default with RFID card reader).
„ The charging process is continued (default without RFID card reader).
14
In operating mode "Time control", the functions of the operating modes "Mains control" and
"Energy Manager" are disabled. The charging capacity is then not controlled by network or
an Energy Manager.