Assembly; Fitting The Loop Handle; Cutting Attachment Guard; Cutting Attachment - Efco 8245 SE Manuel D'utilisation Et D'entretien

en
12

ASSEMBLY

Fitting the loop handle

Fit the handle onto the shaft arm and secure it using screws (A,
Fig.16), washers, and nuts. The handle position is calculated
depending on the requirements of the operator.
CAUTION - Don't assemble the loop handle (B,
Fig.17) between label's arrow (C, Fig.18) and back
handle (D, Fig.17).

Cutting attachment guard

16
WARNING: Never use a cutting attachment without
an approved
Recommended cutting attachments (Page 10). An
incorrect or faulty guard may lead to serious
personal injury.
WARNING: The deflector provided with your stick
edger may not protect the operator from all foreign
objects (gravel, glass, wire, etc) thrown by the
rotating cutting attachment. Thrown objects may also
ricochet and strike the operator.
17
WARNING: Immediately replace a broken or damaged
guard; never try to mount the guard in incorrect
position.

Cutting attachment

WARNING: When fitting the cutting attachment it is
extremely important that the drive flange engages
correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can
result in serious and/or fatal personal injury.
18
WARNING: Always stop the engine before doing any
work on the cutting attachment. The attachment
continues to rotate even after the throttle has been
released. Ensure that the cutting attachment has
stopped completely and disconnect the HT lead from
the spark plug before you start to work on it.
WARNING: Using an incorrect cutting attachment or
an incorrectly sharpened blade increases the risk of
kickback.
WARNING: Always discard a blade that is bent,
twisted, cracked, broken or damaged in any other
19
way (Fig.19). Never attempt to straighten a twisted
blade so that it can be reused. Only use original
blades of the specified type.
WARNING! This machine is not suitable for use with
disc for wood (22-60-80 teeth) and relevant metal
guard.
guard. See the section on