ASSEMBLY
Fitting the loop handle
Fit the handle onto the shaft arm and secure it using screws (A,
Fig. 16), washers, and nuts. The handle position is calculated
depending on the requirements of the operator.
Fitting the cutting attachment guard
16
Fitting the safety guard (Fig.18-19)
Fit the blade guard (A) to the shaft arm with screws (B) in a
position allowing the operator to work safely.
NOTE: assemble the trimmer guard (C, Fig.18) when using the
nylon heads. Secure the trimmer guard (C) to the protection
(A) by means of the screw (D).
WARNING: Never use disks for wood.
WARNING: Never use a cutting attachment without
an
approved
Recommended cutting attachments (Page 10). An
incorrect or faulty guard may lead to serious
personal injury.
18
WARNING: The deflector provided with your brush
cutter may not protect the operator from all foreign
objects (gravel, glass, wire, etc) thrown by the
rotating cutting attachment. Thrown objects may also
ricochet and strike the operator.
WARNING: Immediately replace a broken or damaged
guard; never try to mount the guard in incorrect
position.
19
Assembling the cutting attachment
WARNING: When fitting the cutting attachment it is
extremely important that the drive flange engages
correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can
result in serious and/or fatal personal injury.
20
guard.
See
the
section
en
on
13