Assembly; Cutting Implement Assemblage - Efco PT 2700 Manuel D'utilisation Et D'entretien

ASSEMBLY

Cutting implement assemblage

Put the shaft arm (A, Fig.16) in the cutting implement (B), till the
centering hole on the shaft matches that of the implement.
Fix the centering screw (C, Fig.16) first and then the two screws
(D, Fig. 17).
WARNING! – For all operations before the use of
cutting implement, consult EP120 EF accessory
instruction manual.
16
Shaft adjustment (PTX 2700)
WARNING – Shaft adjustment operations must be
carried out while engine is switched off and chain
cover fi tted.
Unloose locking ring nut (A, Fig.18) clockwise. Adjust shaft to
desired height.
anticlockwise.
17
Cutting tool angular adjustment (EP120 EF)
WARNING – The cutting tool angular adjustment must
be carried out while engine is switched off and chain
cover fi tted.
Cutting tool's angulations can be modified from 0° to 90°
unscrewing screw (B, Fig.20). There are three intermediate
positions between 0° and 90° (22° - 45° - 67°) which block the
cutting tool.
18
After selecting the angle tighten the screw (B).
WARNING – Be aware to block the cutting device in
one of the fi fth positions; don't let it in an intermediate
position.
19
20
Tighten locking ring
en
nut (A, Fig.19)
11