Wolfcraft MASTER cut 2600 Traduction De La Notice D'utilisation Originale page 46

CAUTION USE AS ROUTER TABLE ONLY PERMITTED IN COMBINATION
WITH THE PARALLEL MILLING GUIDE, ART NO. 6901000
SAFETY INFORMATION FOR ROUTERS
• Apart from these machine-specific safety instructions, also observe the safety instructions for the router used.
• Always be aware that the workpiece may unexpectedly get out of control during the routing process and get kicked back.
• Do not use the machine table for curved work.
• Carry out the routing work exclusively with the parallel milling guide available as accessory (art no. 6901000), to prevent kickback
and to prevent your hands from touching the router bit.
• Observe the original instruction manual of the parallel milling guide (art. no 6901000) to ensure correct installation.
• Do not use routers with a rating of more than 1800 W and a voltage of more than 230 V.
• Do not use router bits with a diameter exceeding 27 mm.
• Please observe that the feed must be against the direction of rotation of the router bit.
• From the supplied spacer rings, select the spacer ring appropriate for the size of the router tool. Safe work requires selecting
the smallest possible spacer ring.
• Use only sharp and properly maintained routing tools that have been set in accordance with the tool manufacturer's instructions.
• Observe the data concerning the minimum/maximum speed and the direction of rotation indicated directly on the equipment and
tools used, or on their packaging, or as detailed in the operating instructions.
• Please be aware that the improper use of routing tools, of work pieces and of the guiding devices for the work piece may cause
dangerous situations.
• When routing close to the guide, keep your hands away from the routing tool.
• If possible, use table pressure shoes in addition to the parallel milling guide while routing.
• Support long workpieces on the receiving side to prevent dangerous situations caused by accidental tipping over. The support must
rest on stable ground and have the same height as the machine table, e.g. the roller trestle (art. no. 6102300).
• Only process work pieces that, considering their weight and size, can be held and advanced safely by one person.
• Choose the correct speed that is appropriate for the tool and workpiece. Refer to the operating manual of your router for the exact
speed specifications.
• Observe the maximum permitted workpiece dimensions (see Technical Data).
t
46