Montage; Contre-Poids De Bras De Lecture; Operation - MC Crypt DJ-2650D Notice D'emploi

Montage

Contre-poids de bras de lecture

• Placer le contre-poids de bras de lecture (17) derrière le bras de lecture (13) du tourne-disque. L'échelle du
contre-poids (17) est orientée vers l'avant, en direction du dispositif de prise de son (9).
• Tourner le contre-poids (17) environ jusqu'à la moitié sur le bras de lecture (13). Le
décrit sous le point « réglage du contre-poids du bras de lecture ».
Dispositif de prise de son
• Avant le montage du dispositif de prise de son (9), veiller à ce que le bras de lecture (13) soit bloqué dans l'ap-
pui du bras de lecture (14).
• Placer avec précaution le dispositif de prise de son pré-monté (9) sur le bras de lecture (13).
• Fixer le dispositif de prise de son (9) en tournant la vis de réglage dans le sens inverse des aiguilles d'une
montre.
42
réglage de précision est
• Check through all connections and adjustments again.
• Open the lid.
• Put a record on the turntable (2) Place a single-adaptor (puck) on the turntable axis (3) if needed to play single
• Turn the POWER switch (5) to the ON position.
• Set the speed
• Use the buttons to select the right speed (10) to the settings given on the record player (33 1/3 or 45 rpm). The selec-
• Switch the mixing desk or amplifier on. Select the appropriate input to which the record player is connected.
• Operate the START/STOP button (6) or press Start/Stop on the remote control (mixing desk). The turntable (2) will
• Disengage the support clip on the pick-up arm rest (14).
• Set the pick-up lift lever (15) to the "OPEN" position and swing the pick-up arm (13) from the pick-up arm rest (14)
• If operating in bad light press the locking button for the needle-light (7). The needle light (7) will move into position
• Align the pick-up arm (13) over the desired groove position on the record.
• Lower the head using the pick-up lift by swinging the pick-up arm lift lever (15) forwards. The pick-up arm (13)
• Now set the volume on the amplifier to the desired level.
• If playback should be interrupted, do not touch the pick-up
Settings

Operation

records.
regulator (12) to a middle setting. In this setting the regulator clicks into place and for model DJ-
2650D the LED display will additionally show a green light.
ted speed is then indicated by the LED display.
be begin to rotate.
and over the record.
and switch itself on. To switch it off simply press on the needle light (7) and gently push it into position.
lower itself gently and playback of the record will begin.
button (6).
will
arm (13) but simply press the the START/STOP
31