07/05/01 15:45:14 32Z4P600_008
REFUELING
Recommended Fuel
Unleaded gasoline
U.S.
Pump octane rating 86 or higher
Except U.S.
Research octane rating 91 or higher
Pump octane rating 86 or higher
This engine is certified to operate on unleaded gasoline with a
pump octane rating of 86 or higher (a research octane rating of 91
or higher).
Refuel in a well-ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes may reach flames
or sparks.
You may use regular unleaded gasoline containing no more than
10% Ethanol (E10) or 5% Methanol by volume. In addition,
Methanol must contain cosolvents and corrosion inhibitors. Use of
fuels with content of Ethanol or Methanol greater than shown
above may cause starting and/or performance problems. It may
also damage metal, rubber, and plastic parts of the fuel system.
Engine damage or performance problems that result from using a
fuel with percentages of Ethanol or Methanol greater than shown
above are not covered under warranty.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled
fuel is not covered under the Distributor's Limited Warranty.
1.
With the engine stopped and on a level surface, remove the fuel
filler cap and check the fuel level. Refill the tank if the fuel level
is low.
2.
Add fuel to the bottom of the fuel level limit of the fuel tank. Do
not overfill. Wipe up spilled fuel before starting the engine.
FUEL FILLER CAP
Refuel carefully to avoid spilling fuel. Do not fill the fuel tank
completely. It may be necessary to lower the fuel level depending
on operating conditions. After refueling, screw the fuel filler cap
back on until it clicks.
Keep gasoline away from appliance pilot lights, barbecues,
electric appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental
damage. Wipe up spills immediately.
8
MAXIMUM
FUEL FILLER
FUEL LEVEL
NECK
ENGLISH
ENGINE OIL
Oil is a major factor affecting performance and service life. Use
4-stroke automotive detergent oil.
Recommended Oil
Use 4-stroke motor oil that
meets or exceeds the
requirements for API service
classification SJ or later (or
equivalent). Always check the
API service label on the oil
container to be sure it includes
the letters SJ or later (or
equivalent).
SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the indicated range.
Oil Level Check
Check the engine oil level with the engine stopped and in a level
position.
1.
Remove the oil filler cap/dipstick and wipe it clean.
2.
Insert the oil filler cap/dipstick into the oil filler neck as shown,
but do not screw it in, then remove it to check the oil level.
3.
If the oil level is near or below the lower limit mark on the
dipstick, fill with the recommended oil to the upper limit mark.
Do not overfill.
4.
Screw in the filler cap/dipstick securely.
UPPER LIMIT
Running the engine with a low oil level can cause engine damage.
Engine damage caused by running the engine with a low oil level
is not covered under the Distributor's Limited Warranty.
AMBIENT TEMPERATURE
OIL FILLER CAP/DIPSTICK
LOWER LIMIT