Installing The Handle - Ryobi RTS22 Manuel D'utilisation

INSTALLING WHEELS ONTO THE STAND
See Figure 9.
Wheel .......................................................................2
Washer .....................................................................4
Hex nut (8 mm) .........................................................2
 Slide a washer, a wheel, and another washer onto each
axle.
 Thread a hex nut onto the axle and securely tighten, using
a 13 mm hex wrench.

INSTALLING THE HANDLE

See Figure 10.
 Remove the hex nut from the bolt in the handle but do
not remove the bolt.
 Slide a washer onto the bolt.
 Place the nylon hex nut into the recessed hole on the
back of the height/bevel adjusting handwheel and hold
in place.
 Insert the handle and screw into the hole on the height/
bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
 Cover the end of the handle with the cap.
ASSEMBLY
NUT
16 - English
AXLE
WHEEL
WASHER
WASHER
WASHER
HANDLE
BOLT
WHEEL
Fig. 10
NUT
Fig. 9
END
CAP