Installing The Handle - Ryobi RTS12T Manuel D'utilisation

 Position the table saw onto the stand so that the holes in
the saw's frame are aligned with the holes in the stand's
brackets.
NOTE: Make sure the table saw's frame is flush against
the stand and that all the stand legs are touching the
ground.
 Install carriage bolts through the holes in the brackets
and frame. Secure with wing nuts and tighten securely.
 Be sure the table saw is on level ground and the stand is
sturdy before use.

INSTALLING THE HANDLE

See Figure 11.
 Remove the hex nut from the bolt in the handle but do
not remove the bolt.
 Slide the washer onto the bolt.
 Place the hex nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
 Insert the handle and screw into the hole on the height/
bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
 Cover the end of the handle with the cap.
ASSEMBLY
HANDLE
17 - English
WASHER
BOLT
HANDLE
END CAP
WING
NUT
CARRIAGE
BOLTS
Fig. 10
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
NUT
Fig. 11