Operating Components - Ryobi RTS22 Manuel D'utilisation

OPERATING COMPONENTS

The upper portion of the blade projects up through the table
and is surrounded by an insert called the throat plate. The
height of the blade is set with a handwheel on the front of the
cabinet. Detailed instructions are provided in the Operation
section of this manual for the basic cuts: cross cuts, miter
cuts, bevel cuts, and compound cuts.
The rip fence is used to position work for lengthwise cuts.
A scale on the front rail shows the distance between the rip
fence and the blade.
It is very important to use the blade guard assembly for
all through-sawing operations. The blade guard assembly
includes: riving knife and blade guard with anti-kickback
pawls.
SWITCH ASSEMBLY
See Figure 3.
This saw is equipped with an on/off switch that has a built-in
locking feature. This feature is intended to prevent unauthor-
ized and possible hazardous use by children and others.
TO TURN THE SAW ON:
 Lift the switch to turn ON ( l ).
TO TURN THE SAW OFF:
 Press the switch down to turn OFF ( O ).
TO LOCK THE SAW:
 With the saw turned OFF, install a padlock (not included)
through the hole in the switch.
FEATURES
WARNING:
ALWAYS make sure your workpiece is not in contact with
the blade before operating the switch to start the tool.
Failure to heed this warning may cause the workpiece to
be kicked back toward the operator and result in serious
personal injury.
WARNING:
To reduce the risk of accidental starting, ALWAYS make
sure the switch is in the OFF ( O ) position before plugging
tool into the power source.
11 - English
SWITCH
OFF
SWITCH
ON
Fig. 3