Ryobi RTS22 Manuel D'utilisation page 17

INSTALLING THE SLIDING TABLE
ASSEMBLY
See Figures 11 - 12.
To install sliding table assembly:
 Locate the sliding table assembly.
 Unlock the front and back table locking levers.
 Insert sliding table assembly into table locking levers.
 Push the table assembly until it rests against the saw
table and is completely closed.
 Install phillips head screw into hole on the bottom of the
rear extension rod to hold sliding table assembly into
locking levers.
 Lock the front and back table locking levers.
To install indicator:
 Press the end cap over the front extension rod (see figure
12).
 Locate the indicator.
 Slip the indicator thru the slot in the front rail of the table
and into the rip indicator end cap.
 Fit the top slot in the indicator over the detent on the end
plug and the bottom slot over the screw hole on the end
cap.
 Insert a screw into the bottom slot of the indicator, the
hole in the end cap and the extension rod.
 Align the indicator to the 17 in. mark.Tighten securely, but
do not overtighten. Overtightening may crush extension
rod ends.
STOP
SCREW
REAR
EXTENSION ROD
SLIDING
TABLE
LOCKING
ASSEMBLY
TABLE
LEVER
ASSEMBLY
EXTENSION
ROD
RIP INDICATOR
END CAP
17 IN.
MARK
Fig. 11
17 - English
DETENT
INDICATOR
SCREW
INDICATOR
Fig. 12