Installing/Removing The Battery Pack - Ryobi P553 Manuel D'utilisation

NOTE: The blade provided is fine for most wood cutting
operations, but for fine joinery cuts or cutting plastic, use
one of the accessory blades available from the dealer.
WARNING:
Before starting any cutting operation, clamp or bolt the
compound miter saw to a workbench or an approved
workstand. Never operate the miter saw on the floor or
in a crouched position. Failure to heed this warning can
result in serious personal injury.
WARNING:
To avoid serious personal injury, always tighten the miter
lock knob and the bevel lock knob before making a cut.
Failure to do so could result in movement of the control
arm or miter table while making a cut.
WARNING:
To avoid serious personal injury, keep hands outside
the no hands zone, at least 4 in. from the blade. Never
perform any cutting operation freehand (without holding
workpiece against the fence). The blade could grab the
workpiece if it slips or twists.
WARNING:
Do not start your compound miter saw without checking
for interference between the blade and the miter fence.
Damage could result to the blade if it strikes the miter
fence during operation of the saw. Failure to heed this
warning can also result in serious personal injury.

INSTALLING/REMOVING THE BATTERY PACK

See Figure 23.
 Place battery pack in the saw. Align raised rib on battery
pack with groove inside saw.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
OPERATION
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
transporting, or when not in use. Removing battery pack
will prevent accidental starting that could cause serious
personal injury.
 Locate and depress the latches on each side of the battery
pack to release the battery pack from the saw.
 Remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger.
CUTTING WITH YOUR COMPOUND
MITER SAW
WARNING:
When using a work clamp or C-clamp to secure your
workpiece, clamp workpiece on one side of the blade
only. The workpiece must remain free on one side of the
blade to prevent the blade from binding in workpiece. The
workpiece binding the blade will cause motor stalling and
kickback. This situation could cause an accident resulting
in possible serious personal injury.
WARNING:
NEVER move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade is
rotating. Any slip can result in contact with the blade
causing serious personal injury.
LATCH
19 – English
DEPRESS LATCHES TO
RELEASE BATTERY PACK
LATCH
BATTERY
PACK
Fig. 23