Navigation And Parameter Table - IFM Electronic ecomot200 DW2003 Notice D'utilisation

FA-1
MONITOR

6. Navigation and parameter table

The push buttons
of values and acknowledgement within the parameters arranged in columns.
The parameters above
normally set only once during commissioning depending on the machines or sys-
tems to be monitored.
The parameters below these entries are application parameters. They can be set or
changed more often.
RUN
mode
Indication
of either
Istwert
actual
Eingang
value input
[RPM/Hz]
[RPM/Hz]
Analog-
analogue
ausgang
output
[V/mA]
[V/mA]
page 28
/ and the push button
and
VER
DIM
NOC
CYL
FO1
FH1*
FL1*
*) parameter with teach function
are used for the navigation, entry
are general system parameters. They are
Parameter range
and PRG mode
SO2
FO2
SP2*
HY2
ST2
DT2
FT2
system
parameters
back to the
RUN mode
application
parameters