Star TSP1000 Série Mode D'emploi page 29

(2) Position 2
When using roll paper with an inside core diameter (A): ø25.4 and outside core
diameter (B): ø40
Paper thick-
ness ( µ m)
Level 1
65
80 —
105
(3) Position 3
When using roll paper with an inside core diameter (A): ø 50.8 and outside core
diameter (B): ø58
Paper thick-
ness ( µ m)
Level 1
150 —
C
B
A
Roll paper core
Detected diameter (C)
(Approx. mm)
Level 2 Level 3
ø45
Detected diameter (C)
(Approx. mm)
Level 2 Level 3
ø69
C
– 26 –
Remaining paper length
Level 1
— —
Remaining paper length
Level 1
— —
Note:
1) The adjuster is set to position 1,
level 2 prior to being shipped from
the factory.
2) The C dimension and the remained
paper length are the calculated val-
ues. There may be some variations
in actual mechanism.
3) The remaining paper lengths shown
in the table above are for reference
only. Adjust the near-end sensor to
suit the actual conditions of use.
4) If thick paper is used (100 µm or
greater paper thickness) when the
adjuster is set to position 1, there
will be looseness in the roll paper
itself which makes it easier for de-
tection variations to occur. Set to
Level 3.
(Approx. m)
Level 2 Level 3
5.6
4.4 —
3.2
(Approx. m)
Level 2 Level 3
6.5 —