Star TSP1000 Série Mode D'emploi page 152

Appendix F: Buzzer Driver Circuit
This printer is equipped with a circuit for driving the buzzer. A 6-pin modular
connector for connection of the buzzer is located on the back of the printer. To
connect to the drive circuit, connect the buzzer to the modular connector using a
cable supplied by you like that one shown in the figure below.
Caution
Never connect any other type of plug to the buzzer connector.
Modular plug
Modular plug: MOLEX 90075-0007,
AMP641337, or JAPAN BURNDY B-66-4
Signal
Pin No.
name
1 FG Frame ground
2 DRV1 Drive signal 1
3 +24V Drive power
4 +24V Drive power
5 N.C. Not connected
6 N.C. Not connected
I/O
Function
direction
—
OUT
OUT
OUT
—
—
– 149 –
Shield
6
<Viewed from Connector Surface>
Wire lead
1