Star TSP1000 Série Mode D'emploi page 147

The two-way parallel interface is compatible with the IEEE1284 compatibility mode
and nibble mode. Refer to the separate Specification Manual for details.
Table of Connection Signals for Each Mode
Pin No. Direction
1 In
2 In/Out
3 In/Out
4 In/Out
5 In/Out
6 In/Out
7 In/Out
8 In/Out
9 In/Out
10 Out
11 Out
12 Out
13 Out
14
15
16
17
18 OUT
19~30
31 In
32 Out
33
34
35
36 In
Parallel interface connector (printer side)
Note:
1) The first letter "n" of each signal name indicates that the signal is active
"L". If any one of the above signals is not available, bidirectional commu-
nication cannot be accomplished.
2) In interfacing signals, be sure to use twist-paired wires for signal lines, and
the return side must be connected to signal ground level.
Appendix C: Parallel Interface
Compatibility Mode Signal Name
nStrobe
Data0
Data1
Data2
Data3
Data4
Data5
Data6
Data7
nAck
Busy
PError
Select
—
—
Signal GND
Frame GND
+5V
Twisted Pair Return
nInit
nFault
External GND
—
—
nSelectIn
– 144 –
Nibble Mode Signal Name
AckDataReq/Data2,6
Twisted Pair Return
nDataAvail/Data0,4
This connector mates with an
Amphenol 57-30360 connector
Host Clock
Data0
Data1
Data2
Data3
Data4
Data5
Data6
Data7
PtrClk
PtrBusy/Data3,7
Xflag/Data1,5
HostBusy
—
Signal GND
Flame GND
+5V
nInit
—
—
—
1284Active