Star TSP1000 Série Mode D'emploi page 22

Position 5
Position 4
Position 6
Position 3
Position 2
Position 1
(3) Pull on the edge of the paper to
remove any slack and then push
down both sides of the printer cover
to close it.
Note: Make sure that the printer
cover is securely closed.
(4) If the printer cover is closed after
turning on the power, the cutter op-
erates automatically and the front
end of the paper is cut.
Note: If the cutter does not operate
after the printer cover is
closed, open the cover and
close it again securely.
(5) If necessary, attach the paper stop-
per to the paper cover as shown. The
output tray can hold up to 30 sheets
(width:80-82.5 mm, thickness: 80–
120 µ m, length: 50–150 mm). For
paper with a different thickness or
for other sheet lengths, the limit is
10 sheets.
Note: When attaching the paper
stopper to the paper cover,
position the stopper accord-
ing to the length of the cut
paper. (Refer to the follow-
ing table.)
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
– 19 –
Paper length (mm)
50 – 100
100 – 120
120 – 140
140 – 160
160 – 180
180 – 200