Management; Storage; Transport; Weight - DAB EVOSTA2 Instructions Pour L'installation Et La Maintenance

7. MANAGEMENT

7.1

Storage

All the circulators must be stored in a dry covered place, with possibly constant air humidity, free from vibrations
and dust. They are supplied in their original pack in which they must remain until the time of installation. If this
is not the case, accurately close the suction and delivery mouth.
7.2

Transport

Avoid subjecting the products to needless impacts and collisions. To lift and transport the circulator use lifting
devices with the aid of the pallet supplied with it
7.3

Weight

The adhesive plate on the packaging indicates the total weight of the circulator.

8. INSTALLATION

Always switch off the mains power supply before working on the electrical or
mechanical part of the system. Wait for the warning lights on the control panel to go
out before opening the appliance. The capacitor of the direct current intermediate
circuit remains charged with dangerously high voltage even after the mains power has
been turned off.
Only firmly cabled mains connections are admissible. The appliance must be earthed
(IEC 536 class 1, NEC and other applicable standards).
Ensure that the voltage and frequency on the data plate of the EVOSTA2, EVOSTA2d
circulator are the same as those of the power mains.
8.1

Mechanical installation

A
The arrows on the pump housing indicate the flow direction through the pump. See fig. 1, pos. A.
1. Fit the two gaskets when you mount the pump in the pipe. See fig. 1, pos. B.
2. Install the pump with a horizontal motor shaft. See fig. 1, pos. C.
3. Tighten the fittings.
ENGLISH
(if contemplated).

Figure 2: Mounting EVOSTA2, EVOSTA2d

5
C
B