Hendi 224076 Mode D'emploi page 8

Operation
• Place the iVide circulator stick in a heat-resistant
container hat is sufficiently deep to hold the de-
vice using the clamp.
• Fill the container with water level between the
MIN and MAX markings on the heating element
housing.
a) By control panel:
1. Use the 'Settings' button to select 'Temperature'
and then set the desired value with the '+' and '-'
buttons.
2. Press again the 'Settings' button to select the
required number of hours, again using the '+'
and '-' buttons.
3. Press again the 'Settings' button to select the
required number of minutes, once again using
the '+' and '-' buttons.
4. When you select the temperature and time of
cooking, press the Start/Stop button to start the
appliance. After reaching the required tempera-
ture, the alarm triggers and the temperature led
b) By using the iVide App (replaces steps 1 to 3)
EN
Connect the device (if this is the first time you per-
form this operation, please refer to the information
above). Select the recipe or use the calculator and
then follow the directions on the display. The appli-
cation will automatically select the correct temper-
Compatibility disclaimer
Wireless performance is dependent on your de-
vice's Wi-Fi wireless technology, please refer to
your device's manufacturer. HENDI will not be li-
8
Note: Placing vacuum bag with food will increase
the water level. Check the water level afterwards to
ensure that it does not beyond MAX marking.
• Connect the power cable to the power supply.
Press the Start/Stop button.
stops flashing. Place the bag in water. CAUTION!
Water is hot.
5. After reaching the set cooking time, remove the
bag from the hot water using kitchen tongs.
6. Finish the cooking process by searing the meat
in a pan to obtain the taste of fried meat and
crunchy crust. Add a little butter and briefly sear
the cooked meat on both sides.
7. After the cooking process is finished, disconnect
the device from the power supply and leave it to
cool down before cleaning. To avoid any risk of
burns, leave the water to cool before pouring it
from the container.
ature and time of cooking. Select 'Start cooking'.
The iVide circulator stick will start heating water to
the set temperature.
For safety reasons do not place bags with food in
water before reaching the set temperature.
able for any lost of data or leakage resulting from
the use of these devices.