Hendi 224076 Mode D'emploi page 10

Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are
still unable to solve the problem, please contact the supplier/service provider.
Problems
The appliance does not switch
on.
Error code: "E5" shown on the
display.
Error code: "E2" shown on the
display.
Technical Specification
Item:
Operating voltage & frequency:
Rated input power:
Protection class:
Waterproof protection class:
Temperature range:
Remarks: Technical specification is subjected to change without prior notification.
EN
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
Discarding & Environment
At the end of the life of the appliance, please dis-
pose of the appliance according to the regulations
and guidelines applicable at the time.
10
Possible causes
- Power cord is not connected
properly with the power socket
- The ON / OFF button is not
pressed.
The water drops below the MIN
marking.
The digital thermostat is broken
224076
220 – 240V~ 50Hz
800W
Class I
IPX7
25°C ~ 90°C
when it was purchased and include proof of pur-
chase (e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Throw packing materials like plastic and boxes in
the appropriate containers.
Possible solutions
- Check again the power to make
sure it is connected properly.
- Press the ON / OFF button to
start operation.
Make sure the water level is be-
tween the MAX and MIN mark-
ings during operation.
Contact the supplier.