Machine's Safety Equipment; Throttle Lockout - Gardeo GTHT2575LC Traduction Des Instructions Originales

EYE PROTECTION
Always wear approved eye
protection. If you use a visor
then you must also wear approved
protective goggles.
Approved protective goggles
must comply with standard
EN 166 in EU countries.
GLOVES
Gloves should be worn when
necessary, e.g., when fitting
cutting attachments.
BOOTS
Wear sturdy, non-slip boots or
shoes.
CLOTHING
Wear clothes made of a strong fabric and avoid
loose clothing that can catch on twigs and branches.
Always wear heavy, long pants. Do not wear
jewellery, shorts
sandals or go barefoot. Secure hair so it is above
shoulder level.
FIRST AID KIT
Always have a first aid kit nearby.

Machine's safety equipment

This section describes the machine's safety
equipment, its purpose, and how checks and
maintenance should be carried out to ensure that it
operates correctly. See the "What is what?" section
to locate where this equipment is positioned on your
machine.
The life span of the machine can be reduced and
the risk of accidents can increase if machine
maintenance is not carried out correctly and if
service and/or repairs are not carried out
professionally. If you need further information
please contact your nearest service
workshop.complémentaires,
IMPORTANT !
All servicing and repair work on the machine
requires special training. This is especially true of
the machine's safety equipment. If your machine
fails any of the checks described below you must
contact your service agent. When you buy any of
our products we guarantee the availability of
professional repairs and service. If the retailer who
sells your machine is not a servicing dealer, ask him
for the address of your nearest service agent.
WARNING! Never use a machine
with faulty safety equipment. The
machine's safety equipment
must be checked and
maintained as described in this
section. If your machine fails any
of these checks contact your
service agent to get it repaired.

Throttle lockout

The throttle lockout is designed to prevent
accidental operation of the throttle control. When
you press the lock (A) (i.e. when you grasp the
handle) it releases the throttle control (B). When you
release the handle the throttle control and the
throttle lockout both move back to their original
positions. This movement is controlled by two
independent return springs. This arrangement
means that the throttle control is automatically
locked at the idle setting
Make sure the throttle control is locked at the idle
setting when the throttle lockout is released.
Press the throttle lockout and make sure it returns to
its original position when you release it.