Specific Safety Rules - Gardeo GSEBRTHE18VLI Traduction Des Instructions D'origine

9. Do not operate in poor lighting.Use the unit only indaylight or good artificial light.
10. Keep firm footing and balance . Do not overreach. Overreaching can result in loss of balance or exposure
to hot surfaces.
11. Keep all parts of your body away from any moving part.
12. When using the attachment on a trimmer with a gasoline engine , do not touch areas around the muffler or
cylinder of the power head, these parts fet hot from operation . Failure to do so could result in possible
serious personal injury.
13. Always disconnect from power supply before making any adjustments or repairs expect for carburetor
adjustments.
14. Inspect unit before each use for loose fasteners, damaged or missing parts. Correct before using the
edger attachment. Failure to do so can cause serious injury.
15. Use only original manufacturer's replacement parts. Failure to do so, may cause poor performance,
possible injury, and your warranty.
16. Do not, under any circumstance ,use any attachment or accessory on this product , which was not
provided with the product ,or identified as appropriate for use with this product in the operator's manual.
17. Do not handle the product with wet hands.
18. Do not use the product if the switch does not turn theproduct on or off. A product that cannot be
controlledwith the switch is dangerous and must be repaired.
19. Avoid accidental starting; never carry the product withyour finger on the trigger.
20. Use common sense when using this product.Stay alert and pay attention to what you are doing.
21. Do not force the product. It will do a better job withless likelihood of a risk of injury when you operate itat
the rate for which it was designed.
22. Pull the plug out immediately if the mains orextension lead is damaged or severed.
23. Disconnect the product from the power supply when itis not in use, before servicing and when
changingaccessories.

SPECIFIC SAFETY RULES

For Prunner.
This Prunner is a rugged, powerful device, but you should nevertheless note a few words of advice.
Always make sure that there is enough oil in the oil tank.
The Chain should always be well-oiled, if necessary soak the chain in bio-degradable chainsaw oil
before starting work. You can purchase chainsaw oil based on caster oil from the Hersteller in
quantities of 1 litre or 5 litres. While using the Prunner make sure that the chain is always well-soaked
in oil. If this is not the case manually oil the chain.
Make sure that the oil level does not drop under the minimum mark. Some light smoking is inevitable
and no reason for concern. Lift off the black plastic cover after every use and clean the area under it.
Also clean the pinhole in the oil container lid after each use. Keep the groove in the guide bar clean at
all times.
If the unit fails to oil the chain properly it may well be that the groove is full of saw dust and bark
shavings. Remove the chain and clean out the groove with a suitable tool or blow it out with
compressed air. To keep the unit at top performance the chain must be sharp.
If you notice that the unit's performance is not as it should be and the chain does not eat into the
wood by itself, the chain should be sharpened. Either use the saw chain sharpener or have the chain
sharpened by a professional. When the chain is ground down to the wear mark it should be replaced.
Saw chains are available from the Herstella in sets of two and one drive sprocket. The drive sprocket
should be changed after every second chain.
Page 46 de 65