Basic Working Techniques - Gardeo GTHT2575LC Traduction Des Instructions Originales

• When the engine is switched off, keep your
hands and feet away from the cutting attachment
until it has stopped completely.
• Watch out for stumps of branches that can be
thrown out during cutting.
• Do not cut too close to the ground. Stones and
other objects can be thrown out.
• Check the working area for foreign objects such
as electricity cables, insects and animals, etc, or
other objects that could damage the cutting
attachment, such as metal items.
• If any foreign object is hit or if vibrations occur
stop the machine immediately. Disconnect the HT
lead from the spark plug. Check that the machine is
not damaged. Repair any damage.
• If anything jams in the blades while you are
working, switch off the engine and wait until it has
stopped completely before cleaning the blades.
Disconnect the HT lead from the spark plug.
Safety instructions after completing
work
• The transport guard should always be fitted to
the cutting attachment when the machine is not in
use.
• Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
inspection. Disconnect the HT lead from the spark
plug.
• Always wear heavy-duty gloves when repairing
the cutting attachment. This is extremely sharp and
can easily cause cuts.
• Store the machine out of reach of children.
• Use only original spare parts for repairs.

Basic working techniques

• Work with a swinging action from the bottom
upwards when trimming sides.
• Adjust the throttle setting to suit the load.
• When trimming a hedge the engine should
always face away from the hedge.
• Hold the machine as close to your body as
possible to get the best balance.
• Make sure that the tip does not touch the
ground.
• Do not rush the work, but work steadily until all
the branches have been cut back cleanly.The hedge
trimmer's rear handle can be set in five positions by
pulling out the catch. See figure. When the handle is
adjusted, the hedge trimmer must be idling or not
running.