Location And Installation; Location And Mounting - CDVI CAA480A Série Manuel D'installation

INSTALLATION MANUAL
CAA480A
Elevator Controller
Outputs:
Relay Outputs: 16 Relay Outputs:
Inputs:
Fire Alarm Inputs:
Controller Tamper:
Communication:
Expansion Bus (E-BUS):
Miscellaneous:
Operating Temperature:
Specifi cations may change without prior notice.

3] LOCATION AND INSTALLATION

LOCATION AND MOUNTING

The CAA480A Elevator Controller comes as a printed circuit board (PCB) only or with a
cabinet. The cabinet is designed to allow easy and simple installation of fl oor control wiring,
the backup battery and interface connections. The ideal location to install your CAA480A is
as close
to the elevator control system as possible. This will aid the elevator company by limiting
the amount of wire needed to connect each fl oor that is controlled by the CAA480A.
• Cabinet Dimensions:
39cm (15.5") high x 33cm (13") wide x 10cm (4") deep.
• The cabinet can accommodate:
Up to two 12V, 7Ah, gel cell type batteries and wiring connections.
15cm (6") high x 6cm (2.5") wide x 10cm (4") deep.
• Multiple Conduit Knock-outs:
Two 2.5cm (1") or 3.1cm (1.25") and one 1.2cm (0.5") or 1.9cm (0.75") on each side.
• Minimum Clearance for Cabinet:
25cm (10") clear space around all sides.
38cm (15") clear space in front of cabinet.
• Minimum Clearance from Electrical Interference:
2.4m (8ft.) from high voltage equipment wiring and from electrical equipment likely
to generate interference.1.2m (4ft.) from telephone equipment or lines and 8m (25ft.)
from transmitting equipment.
cdvi.com
4
cdvigroup.com
15A (tested by UL at 10A) @ 16VDC Resistive
1 N.C.
1 N.C.
RS-485, Plug and Play
0°C to 49°C (32°F to 120°F)