Destination Reporting Module (Drm) - CDVI CAA480A Série Manuel D'installation

INSTALLATION MANUAL
CAA480A
Elevator Controller
Figure 18: CAA480A's LEDs:
Green "+12V RELAY" LED: (ON) Floor
control relays are receiving required
12VDC to operate.
Green "BATT" LED: (ON) backup
battery detected.
Red "RX" LED: Flashes
whenever receiving data
through the E-BUS.
E-BUS
RX TX
Red "TX" LED: Flashes
whenever the CA-A480-A
is transmitting data
through the E-BUS.
Green "STATUS" LED: (Flashing)
Firmware is running smoothly.
Future Use

17] DESTINATION REPORTING MODULE (DRM)

Normally, when a user presents their access card to the reader in the elevator car,
the CAA480A will activate and allowaccess to all the fl oors that the user is allowed to.
Though the controller will register the event, if the user has access to more than one
fl oor, you won't know which fl oor the user has accessed. With the Destination Reporting
Module (DRM - sold separately), the controller can register the user who accessed
the elevator and which fl oor was accessed, thus supplying an effective fl oor trace for each
card holder. Destination Reporting is also known as One Card, One Floor operation
as it only allows one fl oor selection to be made per presentation of the card.
AC
BATT REVERSED
12V
+12V RELAY
BATT
E-BUS
A+ A
LOW HIGH
B-
B
GND
LOW HIGH
TAMPER
EOL
TAMPER
COM1
E-BUS
NO1
RX TX
NC1 Position Technology
COM2
NO2
NC2
COM3
NO3
NC3
COM4
STATUS
NO4 FREE ACCESS
COMM FAILURE
NC4
BATT TROUBLE
CA -A480 -P
RL5 RL6 RL7 RL8 RL9
STATUS
FREE ACCESS
COMM FAILURE
BATT TROUBLE
Green "AC" LED: (ON) AC power
is present.
Red "BATT REVERSED" LED: (ON)
Backup battery is hooked up in reverse
Green "12V" LED: (ON) CA-A480-A
panel is receiving the 12VDC required
to operate.
AC
AC
BAT+
BAT-
+12V
+12V
GND
AC
GND
BATT REVERSED
FC
12V
+12V RELAY
FC
BATT
NC16
NO16
COM16
NC15
NO15
COM15
NC14
ADRESS 1
ADRESS 2
NO14
ADRESS 4
ADRESS 8
COM14
RLY COMMS
RLY OFF/ON NC13
DRM ENABLED
PWR OFF/ON NO13
RL10 RL11 RL12
COM13
Green "FLOOR RELAY" LED: (ON)
Floor control relay is activated.
All 16 floor control relays have an LED.
Red "COMM FAILURE" LED: (ON)
The CA-A480-A has lost communication
with the CT-V900-A Controller.
Red "BATT TROUBLE" LED: (ON)
The backup battery has dropped
to 10.5VDC or lower.
cdvi.com
21
cdvigroup.com