Connecting Ac Power - CDVI CAA480A Série Manuel D'installation

INSTALLATION MANUAL
CAA480A
Elevator Controller
Figure 2: Tamper Switch Installation
!
If you are not using a tamper switch be sure to short the tamper inputs by connecting a wire between
the two "TAMPER" terminals.

5] CONNECTING AC POWER

A 15A AC power source with a dedicated breaker and an isolated ground is recommended.
Connect a 16VAC, 40VA (minimum) transformer to the CAA480A's "AC" terminals
and mount it near the cabinet. Refer to Figure 3.
Figure 3: Connecting AC Power
!
Do not power up the CAA480A Elevator Controller until all connections and the CAA480A
settings are completed.
cdvi.com
6
cdvigroup.com
E-BUS
A+
B-
CA-A-A480-A
GND
ELEVATOR
TAMPER
CONTROLLER
TAMPER
AC
AC
BAT+
BAT-
+12V
+12V
GND
GND
FC
FC
Elevator Controller
INSERT BRACKET IN
CABINET SLOT
TAMPER SWITCH
TRANSFORMER TR16/40
16VAC, 40VA, 50/60Hz, Class 2
CD VI
TR1 6/40
CA-A480-A
METAL
BRACKET