Arktic 274224 Mode D'emploi page 9

II). To serve with cold drinks
• Press the corresponding bowl button (
) until lights up.
• Enter to juice temperature setting mode by long
pressing until "PR" is blinking on the display.
• Press again to select bowl 1(F1) or 2(F2) until
"F1" or "F2" is shown on the temperature display.
• Press left panel to adjust the temperature
from 1°C ~ 7°C. The temperature will be set suc-
cessfully. After flashing 15 times without any op-
eration, the display will return to normal.
Fig. 8
Step 1
8 P
.
Step 2
III). To stop working
• Press the corresponding bowl button (
• Next, press consecutively until OFF mode,
d) To simply clean the corresponding bowl:
• Press and hold the corresponding bowl button
Bowl I Bowl I I
( or ) for about 6 seconds..
• The corresponding bowl valve will be fully open
for cleaning about 3 minutes. During this mode,
the control display will show "°C".
Attention: Under this mode, the solenoid valve of
the corresponding bowl will open and no refrig-
Bowl I
or
R
. .
Bowl I
or
Bowl I I
Notice:
• Current temperature is showing on display as
normal.
• Press and
default temperature( 2°C ).
• Display shows "PR" / "F1" / "F2" : Juice temper-
ature setting mode / bowl 1 / bowl 2. The mode
will become invalid after flashing 15 times with-
out any operation and display will switch back to
normal.
• Only left
bowl 1 and 2) within juice temperature setting
model.
Step 3
Step 4
Bowl I I
). will be lighted. Then, it would stop stirring
and refrigerating.
erant gas flow out. But the auger still stirring for
cleaning. Please fill with warm and clean water
into the bowl not exceeding the "MAXIMUM LEVEL".
Do not put your hand inside.
Switch OFF the machine and unplug it for thorough
cleaning or sanitization to the machine.
at the same time for restoring to
panel can be operated (for both
EN
9