Arktic 274224 Mode D'emploi page 15

g) Cleaning the drip tray
Attention: The drip tray should be emptied and
cleaned every time the red float installed in the grid
rises into view. It should be cleaned daily.
• Lift the tray with the grid on top of it and pull it
out.
• Wash the tray and the grid separately with the
lukewarm water.
• Dry both parts well and place back the grid on
top of the tray.
• Position the drainage hose in the opening pro-
vided.
• Fit back the tray in place and press down to se-
cure it with the machine.
h) Lighting lid
Attention: During the cleaning process, take care
not to bend, break or damage the „contacts". Any
damage might cause a bad functioing of the light-
ing lid.
• Clean the lid contacts using a damp cloth and dry
well. Always switch OFF the machine.
• Do not immersed in water for cleaning.
i) Bulb replacement
• The bulb should be replaced only when the ma-
chine is switched OFF and the power cord is un-
plugged.
• Next, remove the protection caps. Then, using a
proper screwdriver (not supplied) to loosen the
screws in order to remove the cover.
• Remove the bulb (U) from the socket (T). And re-
place it with a new bulb (not supplied).
Fig. 24
Fig. 25
Fig. 26
Fig. 27
15
EN