Arktic 274224 Mode D'emploi page 13

e) Reassembly the washed components
Attention: All of the washed components must be
carefully re-assembled. Some components must
be adequately lubricated by the supplied lubricants
in order to ensure that they work efficiently.
• Always check for the integrity of the seal (A),
should it be worn, replace it with a new one (sup-
plied).
• Replace the auger seal hat cover (A) for at least
every 12 months.
• Insert the auger seal hat cover (A) as below (See
Fig. 17).
• Lubricate the inside area of the auger seal hat
cover (A) as shown in Fig. 18 with the lubricant
(Supplied).
• Then, insert the bowl seal ring (B) and lubricate
with the supplied lubricant around it as below
(See Fig. 19).
• Next, insert the auger with the white washer (D)
and black washer (E) for the shaft. Rotate the au-
ger to engage it.
Fig. 17
Fig. 18
Fig. 19
EN
Fig. 20
13