Arktic 274224 Mode D'emploi page 16

j) Cleaning the condenser
• Attention: The condenser can only be cleaned
solely by a specialized technician, who must or-
ganize all of the operational sequences and with
suitable tool/equipment.
• The condenser should be cleaned regularly (at
least once per every 6 months) to keep good ma-
chine performance.
• To access the condenser, the safety guards need
to be removed.
• Warning: Removing safety guards will expose
some sharp surfaces of the machine.
• To remove the safety guard panel, proceed as
below:
1) Lift and completely remove the upper part of the
side guard;
2) Loosen the 4 screws securing the guard in place.
3) After removing the 4 screws, take off the safety
guard. (See Fig. 29)
4) Use a dry brush (not supplied) to remove the dust
that has built up over time with use. (See Fig. 30)
5) After having thoroughly cleaned the condenser,
re-assembly the safety guard.
EN
k) Periodic maintenance
This machine must be periodically checked (for at
least every 6 months) by a specialized technician.
This periodic check serves to ensure that all the
components installed and the machine itself are at
a high level of safety.
16
Any worn components must be replaced by an orig-
inal spare part. It is forbidden to use this machine
when even only one of its components is faulty
or worn. User are prohibited to perform periodic
maintenance.
Fig. 28
Fig. 29
Fig. 30